Command Communications ComSwitch 8500-t Uživatelský manuál stáhnout pdf (Strana 14)

Special Operating Notes

Before operating the CS8500-t, be sure that you understand the following information concerning the

telephone equipment that is used with the CS8500-t.

FAX CNG Tone: Most faxes send an audible beep tone called CNG (CalliNG) tone. This tone is a

distinct beep that repeats every three (3) seconds.

Once a fax has dialed the destination fax number, it generates this tone while waiting for the receiving fax

to answer.

Not all faxes transmit this tone when they place a call. Most, but not all faxes produce this tone through

their auto-dial feature, speed-dial memory position, or by the operator pressing the fax machine's start

button after the number is dialed.

For best results, callers should have your fax number programmed into their fax machine's "speed-dial"

memory.

Programming

Hearing-Impaired Instructions

1. Plug a single line tone telephone into the PHONE port of the CS8500-t

2. Pick up the telephone handset (the PHONE LED will light)

3. Unplug power, then plug power back in

4. The FAX LED will light to indicate access to the programming mode

5. Enter the desired change(s), then press (the TTY/TDD LED will flash three times

acknowledging your changes). Enter additional changes (if desired)

6. Press again to end programming mode; the FAX LED will turn off

7. Hang up the phone

11 CS8500-t Operator’s Guid

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Žádné komentáře

Command Communications ComSwitch 8500-t Uživatelský manuál Strana 14